Description
Product: LED Flexbile 5050 tape strip
SKU: 4-5050N15D
Basic Technical Data
- Standard size: 196” (500CM)/Roll;
- LED Quantity: 150pcs LED/Roll;
- Working voltage: 12V DC
- Working current: 2A
- Life spam:50,000 hours
- No ultra violet (UV/IR) radiation. No mercury.
- Allow to cut per 3 led/circuit(2inch)
- Single run max length: 392inch
- Color: White, Warm white, Red, Green, Blue
Application
- Cove lighting
- Path and contour lighting
- Backlight or dege lighting for signage
- Architectural lights for Canopy, Corridor, Window, Archway
- DIY Lights for home use
- Marine light
- Task lighting
- Replacement of Fluorescent light
- Decorative lights for holiday, event, show, exhibition
Assembly Information
- Solder connection should on be performed on designated solder pads (marked “+/-). During soldering, do not exceed the maximum soldering time of 10 seconds and the maximum soldering temperature of 260 Celsius degrees.
- The smallest unit(100mm-3led) can be removed by cutting with scissors between the designated solder pads;
- The mounting of the strip is facilitated by means of the double-sided adhesive on the back-surface of the strip. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coating as well as dirt partied. The mounting substrate must have sufficient structural integrity. Take care to completely remove the adhesive backing. Once the strip is appropriately positioned. Press on the strip with about 20N/cm2 (refer to application techniques of 3M adhesive transfer tapes).
- The minimum bending radius is 2cm. The strip may be bent over a smaller radius of the circuit board containing no electronic components and such bends should be made once in position to avoid cyclic fatigue.
Safety Information
- The strip itself and all its components may not be mechanically stressed;
- Assemble must not damage or destroy conducting paths on the circuit board.
- Installation of LED modules( with power supplies) needs to be made with regard to all applicable electrical and safety standards. Only qualified personal should be allowed to perform installations.
- Correct electrical polarity needs to be observed. Wrong polarity may destroy the strip.
- Parallel connection is highly recommended as safe electrical operation mode.
- Serial connection is not recommended. Unbalanced voltage drop can cause hazardous overload and damage the strip.
- Please ensure that the power supply is of adapters power to operate the total load.
- When mounting on metallic or otherwise conductive surfaces, there needs to be an electrical isolation points between strip and the mounting surface.
- Pay attention to standard ESD precautions when installing the strip.
- Damaged by corrosion will not be honored as a materials defect claim. It is the user’s responsibility to provide suitable protection against corrosive agents such as moisture and condensation and other harmful elements.
Application Effect:
Packing:
Other Related Color Tape Strip:
Shipping / Payment / Service / Others:
